Bulova

 


Home Search Aetna Airline Atwater Kent. Bendix Blaupunkt Bogen Bowers Breting 14 Bulova Crosley Delco Dentron Electro-Neutronics Emerson Emud Fairbanks Morse Grant, W. T. Grebe Grundig Grunow Hammarlund Hallicrafters Heathkit Henry Hickok 288X Howard Howard Johnson Jesse French Johnson Korting Lafayette Lap Amp Motorola NAD National. Nordmende Norelco Packard-Bell Perpetuum-Ebner PHILCO Philips PYE P35 RCA Robyn T-123B SABA Silvertone 4663 Standard A Stewart Warner Telefunken Triplet 3436 vhf gen Wagner Walgreen WEGA Westinghouse Yaesu ZENITH Links Audio Reinforcement Antenna Cabinet Finishing Capacitor stuffing Comments Dial Scales Dim Bulb Tester Electrodynamic Electrostatic Elmer is his name. Etching Emblems IF Transformers Lead Twister Leakage Tester Packing Tips Resistors Rodent Damage Shiny Chassis Slides & Presentations Tube Analyzing Vendors Laptop

 

 

 

This radio is  " The Companion"  by Bulova, Model 249 Raw Hide, 247 Sun Tan or 246 Blue.  It is a 4 tube AC/DC radio.  

im000158.jpg (49822 bytes)  Click on thumb nail to enlarge.

 

Case Repair

Below is detail of the leather case repair.   The stitching had simply rotted away and turned to a dusty remain.  Once the chassis was removed the stitches fell apart leaving both end pieces flapping.   

The first step was to clean and condition the leather so any work would not simply split brittle leather. Clorox Clean up worked great to remove the dirt and grime.  It did not change any colors on the radio.  Kiwi Leather Lotion for all colors, was used.  The lotion was generously applied and allowed to soak in.  The inside edge of the leather where the stitches poke through was also generously treated to lotion.  The lotion also squished through the stitch holes. The leather then became quite soft.

Next the old stitching was pulled out with tweezers.  It removed easily since each stitch had broken when lightly pulled.   The original stitching is an interlock stitch.  That is where one thread (sting in this case) is pushed through with a needle and a shuttle is threaded through the loop.  Then the thread is pulled back tight and the intersecting "X" (where each of the two threads cross) is centered between the leather panels.  1/8 inch cardboard is glued and riveted to the outer leather.  The crossing point winds up in between the intersecting edges of the cardboard. 

The existing thread holes were used for the new string.  The needle was used to search for the path of the original stitch.  Two passes were made with the thread. The fist pass stitched every other span.  The return path placed a stitch on the open span.  I actually found sewing these two seems quite relaxing.  Just be prepared with some pliers to push the needle through new leather.  Only push through new leather if the original hole is torn.  In this case it was only one hole at the rear, the first hole used to begin the run. 

Have a look at the pictures showing the repair of the case.  Electronic restoration pictures and text will be added later.  There was an interesting Aerovox  brand Resonant capacitor that needed replacement.  And is detailed in the electronics section.

 

im000158.jpg (49822 bytes)

After cleaning and re-stitching. 

I do have the tuning dial for this radio. I only need to make a strap.

Parts lay out, cleaning and leather treatment.

im000153.jpg (53265 bytes)

Clorox Clean up to clean the case.  Kiwi Leather Lotion used to soften the leather.

im000154.jpg (48238 bytes)

Establishing the first stitch, anchor knot and loop

im000155.jpg (55382 bytes)

Periodic hole  alignment and searching for the original string path was done.

im000156.jpg (44933 bytes) 

Newly finished stitching

im000157.jpg (39824 bytes) 

Second picture of new stitching.

A new rear cover snap/strap is needed and the leather carry strap.  These will be repaired later. Pictures to follow. 

 

 

Electronics Restoration

 

Below are just a few comments that were posted on the news:rec.antiques.radio+phone usenet group and the  Antique Radio Forum.

There is an Aerovox Resonant 0.1 uf resonant capacitor (resonalnt at 455Khz)  between circuit common and chassis.  I performed some tests to verify it's resonance and to better understand its function.  But to no avail.  It was eventually replaced with a UL rated Safety Cap of the same capacitance.  

With out the capacitor at all the radio experience "Birdies" all across the dial.  With the original Resonant Cap some birdies were experienced high on the tuning band.  See below test results:

bulletLine at 117vac; original selenium rectifier; 8 volts across filament string.
bulletNo resonant cap - Birdies all over the band from 1620 to 530.
bulletOriginal Resonant cap back in - Birdies from 1620 to 1500
bulletNew 0.1 uf Safety - Same birdies as Resonant cap.

 

bulletReplaced Selenium with Silicon and 180 ohm 2w resistor (tweaked for 6.20
volts across filament string (1.4v rated filaments all 4 tubes including the
3V4) at 120 vac) -
bulletInput AC Resultant
120 Same birdies as new 0.1uf non res.
117 One birdie at ~1600
109 No birdies at all.
bulletAfter alignment at 120 vac one birdie remained with very clear strong
reception.   Receives well at 117vac and Ok at 109 vac.
bulletTweaked lead wires around oscillator coil and eliminated the last birdie!

 

A few theories on the resonant capacitor's purpose are discussed at  http://antiqueradios.com/forums/Forum11/HTML/006043.html.  

Here is a detailed description of the capacitor and how it works:

http://www.philcorepairbench.com/tips/svctip37.htm

and

http://www.philcorepairbench.com/tips/svctip37a.htm 

 

The operation of the radio is quite acceptable and with out birdie once the new capacitor was installed, the rectifier replaced and the filament series string voltage adjusted with an added series resistor (just after the new 1N4004 silicon rectifier) to set the voltage at four (4) times 1.4 volts.  The 1.4 volts is the specified voltage for all four tubes in the radio.  The operation line voltage in my shop is ~117vac.  The isolation transformer was set to 120 for final testing of the restoration.

 

 Contact me including your thoughts and comments. 

Please see the LINKS page.  I have collected many resources over the years.

135,912 unique web site visitors (14,499,000 hits) from October 2004 through August 2011.

Copyright 2004 - 2012. All rights reserved.